How to enable spanning-tree portfast edge on a port on the switch

Configurare noua (How To)

Situatie

If you want to activate spanning-tree portfast edge you must use the following commands:

Solutie

  • enable – to enter the exec mode of the switch
  • configure terminal – to enter the config mode of the switch
  • interface x – where x is the interface you want to use
  • spanning-tree portfast edge
  • end – to return to the exec mode of the switch
  • write – to save the changes made.

Tip solutie

Permanent

Voteaza

Up Down
(4 din 9 persoane apreciaza acest articol)
Share
Tweet
Share

Despre Autor

Leave A Comment?