073-210 Tray 3 Lift Fail RAP

BSD-ON: BSD 7.11 Tray 3 Paper Stacking (3TM)
BSD-ON: BSD 7.20 Tray 3 Paper Stacking (TTM)

073-210 Tray 3 lift NG has occurred three consecutive times.

Initial Actions

• Check for obstructions behind the tray.
• Ensure that the tray is loaded correctly.
• Ensure the tray is pushed fully home.

Procedure

WARNING: Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury.

Refer to the procedures that follow as necessary:

• GP 6 How to Check a Motor.
• GP 7 How to Check a Sensor.

Perform the steps that follow:

1. Enter dC330, code 073-102. Check the tray 3 level sensor, PL 80.20 Item 6.
2. Enter dC330, code 073-002. Check the tray 3 feed/lift up motor, PL 80.20 Item 4.
3. Enter dC330, code 042-003. Check the main motor,PL 40.10 Item 10.
4. Check the drive gears, PL 80.20 for wear or damage. Install new components as necessary.
5. (3TM Only) Check the drive system between the bottom plate and the tray 3 feed/lift motor for operation failure. Install new components as necessary, PL 70.20.
6. (TTM Only) Check the drive system between the bottom plate and the tray 3 feed/lift motor for operation failure. Also check the bottom plate lift mechanism. Install new components as necessary, PL 70.66.
7. If the fault persists, install new components as necessary:

• 3TM PWB, PL 70.23 Item 5.
• TTM PWB, PL 70.90 Item 1.

**This RAP is from Xerox Service Manual. All brand names and trademarks are their respective owner’s property.**

You may be also interested in below toner and drum chip (CRUM) for Xerox VersaLink C7020, C7025, C7030, C7000.

Toner Chip (For North America and West Europe Region): ex:106R0374

Toner Chip (For South America and East Europe Region): ex:106R03749

Drum Chip:ex:113R00782